![\"\"](\"https:\/\/www.mixertube.com\/wp-content\/uploads\/2025\/04\/160630160956s-l1600-2-300x300.jpg\")
![\"\"](\"https:\/\/www.mixertube.com\/wp-content\/uploads\/2025\/04\/ZT121-70-300x300.jpg\")
<\/p>\n <\/p>\n
Specification:
\nMaterial: wire+metal
\nColor: as pic shows
\nSize: approx. 1.38*0.79inch\/3.5*2cm (D*H)
\nEffective surface of the knife: 25mm (0.98inch)diameter
\nLine length: approx. 49.21inch\/125cm (Including alligator clips)<\/p>\n
Two ways to connect this item:
\nif your interface board has the limit switch port or other probe port, you can connect it to that port
\nif your interface board does not have that port, your driver board has that port, you can connect it to the driver board’s limit switch port
\nthen in the Mach 3, you need to setup the probe(Mach3 — Config—Ports and Pins—Input signals Probe enabled , the pin number type the one you use) and the Auto-Tool-Zero. in the attachment, it is the code, you can edit it as your requirements<\/p>\n
Usage:
\nThe wire connect on the control panel interface.
\nThe clip and the control board GND (negative) is connected.
\nThe tool can be clamped portion of the operation when the knife with a clip.
\nWhen the tool contacts the knife\u00a0 that the process is complete.<\/p>\n